Control Panel Modules

Fire-Lite AIM-4A Audible Isolation Module with Unsupervised Signal Circuits

AIM-4A|FL-AIM4A

fire-lite mmf-300-10a ten-input monitor module

Fire-Lite MMF-300-10A Addressable 10-Input Monitor Module, 10-Input (Class B) or 5-Input (Class A), ULC Listing

MMF-300-10A|FL-MMF30010A

Fire-Lite CMF-300A Intelligent Addressable Control Module

CMF-300A|FL-CMF300A

Fire-Lite MMF-301A Miniature Addressable Monitor Module for Style (Class A) or Style (Class B) Circuit of Dry-Contact Input Devices

MMF-301A|FL-MMF301A

fire-lite mmf-302-6a six zone interface module

Fire-Lite MMF-302-6A Six-Zone Conventional-Detector Interface Module, ULC Listing

MMF-302-6A|FL-MMF3026A

fire-lite 2-wire detector monitor module

Fire-Lite MMF-302A Standard-Sized Interface Module for Two-Wire, 24 V, Smoke Detectors on Style (Class A) or Style (Class B) Circuit, ULC Listing

MMF-302A|FL-MMF302A

Fire-Lite I300A Fault Isolator Module, ULC Listing

I300A|FL-I300A

fire-lite mdf-300a addressable control module

Fire-Lite MDF-300A Addressable Dual Monitor Module with Independent Class Circuits

MDF-300A|FL-MDF300A

Fire-Lite MMF-300A Standard-Sized Addressable Monitor Module for Style (Class A) or Style (Class B) Circuit of Dry-Contact Input Devices

MMF-300A|FL-MMF300A

Honeywell CH19000301 Interface Module Accessory, RS-485

CH19000301|HCH19000301

Signal Communication

SigCom 693-0457 DVS-Remote Mic Interface Board

693-0457|AN-6930457

Napco FWC-FSLC-SOM1 Supervised Output Module, 2A at 24VDC, Red / Green LED

FWC-FSLC-SOM1|NA-FWCFSLCSO

Federal Signal EM3 Tone Extension Module

EM3|QF-EM3

SAE FE-A1349 LHD Monitor Module Interface

FE-A1349|O6-FEA1349

Fire-Lite CMF-300-6A Supervised Control Module and SYNC-1 Accessory Card, 6-Circuits

CMF-300-6A|FL-CMF3006A

Potter Electric Signal, LLC

Potter 1119664 LRM Leak Rate Monitor

1119664|PL-1119664

Federal Signal K859901990A Supervisory Diode Module

K859901990A|QF-CPSUPERDI

Napco FN-CTM City Tie Module for GEMC Fire Alarm Control Panel

FN-CTM|NA-FNCTM

Napco GEMC-128MB-R Replacement Motherboard for 128-Zone GEMC Control Panels

GEMC-128MB-R|NA-GEMC128MB

Fire-Lite SLC-3LS 318-Point Addressable SLC Signaling Line Circuit Expander Card for ES-1000X

SLC-3LS|FL-SLC3LS

Honeywell 49840600 Special Video XO USB IFace IO MIO+EIO

49840600|H49840600

Honeywell ANU-48 LED Driver Module, 24V DC

ANU-48|LE-ANU48

Bosch

Bosch DS7457IF Input Module for Fire, Single-Zone

DS7457IF|DS-DS7457IF

Kidde FSUIM Universal Interface Module

FSUIM|ED-FSUIM

Light Engineered

Light Engineered LDM-32 PREMOUNT and WIRE LED DRIVER MOD

LDM-32|LE-LDM32

Kidde SIGA-CC1 SINGE INPUT(RISER)MODULE

SIGA-CC1|ED-SIGACC1

System Sensor

System Sensor MDL3WA Sync-Circuit Module, 12/24V, White

MDL3WA|BK-MDL3WA

Fire-Lite CRF-300-6A Addressable 6-Relay Control Module, ULC Listed

CRF-300-6A|FL-CRF3006A

AIM-4AFL-AIM4A

Fire-Lite AIM-4A Audible Isolation Module with Unsupervised Signal Circuits

AIM-4A|FL-AIM4A

Key Features

Mounting 4” X 4” X 2.8” Standard box
Weight 5 oz.
Indoor Operating Temperature 32°F to 120°F (0°C to 49°C)

MMF-300-10AFL-MMF30010A

Fire-Lite MMF-300-10A Addressable 10-Input Monitor Module, 10-Input (Class B) or 5-Input (Class A), ULC Listing

MMF-300-10A|FL-MMF30010A

Key Features

Ten addressable Class B or five addressable Class A initiating device circuits
Rotary address switches
Mounting hardware included

CMF-300AFL-CMF300A

Fire-Lite CMF-300A Intelligent Addressable Control Module

CMF-300A|FL-CMF300A

Key Features

Built-in type identification automatically identifies these devices to the control panel.
Internal circuitry powered directly by two-wire SLC loop. The CMF-300(A) module requires power (for horns, strobes, etc.).
Integral LED"blinks" green each time a communication is received from the control panel and turns on steady redWhen activated.

MMF-301AFL-MMF301A

Fire-Lite MMF-301A Miniature Addressable Monitor Module for Style (Class A) or Style (Class B) Circuit of Dry-Contact Input Devices

MMF-301A|FL-MMF301A

Key Features

Built-in type identification automatically identifies this device as a monitor module to the panel
Powered directly by two-wire SLC loop. No additional power required
High noise (EMF/RFI) i mmunity

MMF-302-6AFL-MMF3026A

Fire-Lite MMF-302-6A Six-Zone Conventional-Detector Interface Module, ULC Listing

MMF-302-6A|FL-MMF3026A

Key Features

Transmits the status of a zone of two-wire detectors to the fire alarm control panel.
Six addressable Class B or three addressable Class A initiating device circuits.
Status conditions are reported as normal, open, or alarm.

MMF-302AFL-MMF302A

Fire-Lite MMF-302A Standard-Sized Interface Module for Two-Wire, 24 V, Smoke Detectors on Style (Class A) or Style (Class B) Circuit, ULC Listing

MMF-302A|FL-MMF302A

Key Features

MMF-300(A) is a standard-sized module that supervises either a Style D (Class A) or Style B (Class B) circuit of dry-contact input devices.
MMF-301(A) is a miniature monitor module a mere 1.3" (3.302cm) used to supervise a Style B (Class B) circuit of dry-contact input devices.
MMF-302(A) is a standard-sized module used to monitor and supervise compatible two-wire, 24 volt, smoke detectors on a Style D (Class A) or Style B (Class B) circuit.

I300AFL-I300A

Fire-Lite I300A Fault Isolator Module, ULC Listing

I300A|FL-I300A

Key Features

Directly powered by SLC loop without the need for external power
LED that blinks to indicate normal conditions and turns solidWhen short circuit conditions are detected
High noise i mmunity

MDF-300AFL-MDF300A

Fire-Lite MDF-300A Addressable Dual Monitor Module with Independent Class Circuits

MDF-300A|FL-MDF300A

Key Features

Built-in identification automatically recognizes this device as a monitor module
SEMS screws with clAing plates for & easierWiring
LED that flashes green during normal states, and turns a solid red during an alarm

MMF-300AFL-MMF300A

Fire-Lite MMF-300A Standard-Sized Addressable Monitor Module for Style (Class A) or Style (Class B) Circuit of Dry-Contact Input Devices

MMF-300A|FL-MMF300A

Key Features

Built-in type identification automatically identifies this device as a monitor module to the control panel
Powered directly by two-wire SLC loop. No additional power required
High noise (EMF/RFI) i mmunity

CH19000301HCH19000301

Honeywell CH19000301 Interface Module Accessory, RS-485

CH19000301|HCH19000301

693-0457AN-6930457

Signal Communication

SigCom 693-0457 DVS-Remote Mic Interface Board

693-0457|AN-6930457

FWC-FSLC-SOM1NA-FWCFSLCSO

Napco FWC-FSLC-SOM1 Supervised Output Module, 2A at 24VDC, Red / Green LED

FWC-FSLC-SOM1|NA-FWCFSLCSO

EM3QF-EM3

Federal Signal EM3 Tone Extension Module

EM3|QF-EM3

Key Features

Reliable solid-state circuitry
Indoor or outdoor use
No separate power supply required

FE-A1349O6-FEA1349

SAE FE-A1349 LHD Monitor Module Interface

FE-A1349|O6-FEA1349

CMF-300-6AFL-CMF3006A

Fire-Lite CMF-300-6A Supervised Control Module and SYNC-1 Accessory Card, 6-Circuits

CMF-300-6A|FL-CMF3006A

Key Features

Removable 12 AWG (3.31 mm2) to 18 AWG (0.821 mm2) plug-in terminal blocks
Status indicators for each point
Unused addresses may be disabled

1119664PL-1119664

Potter Electric Signal, LLC

Potter 1119664 LRM Leak Rate Monitor

1119664|PL-1119664

Key Features

Automated NFPA 13 and NFPA 25 leak rate testing
Monitors new or existing systems
Monitors supervisory gas source

K859901990AQF-CPSUPERDI

Federal Signal K859901990A Supervisory Diode Module

K859901990A|QF-CPSUPERDI

Key Features

All Call Point models feature a GRP enclosure that is UV stable, anti-static, flameproof, and resistant to heat, impact, and corrosion. The GRP enclosure makes Federal Signal’s Call Points extremely durable to withstand pressure, damage, and environmental elements, making it an ideal solution for all industrial, hazardous, and Fire applications.

FN-CTMNA-FNCTM

Napco FN-CTM City Tie Module for GEMC Fire Alarm Control Panel

FN-CTM|NA-FNCTM

Key Features

Connects GEMC Fire Alarm Control Panel to a city tie monitoring circuit
Provides power to trip the Master Box Trip Coil during an alarm
Specifically designed for use with Napco’s GEMC series fire panels

GEMC-128MB-RNA-GEMC128MB

Napco GEMC-128MB-R Replacement Motherboard for 128-Zone GEMC Control Panels

GEMC-128MB-R|NA-GEMC128MB

Key Features

Designed for mid-sized commercial fire alarm systems
Easily replaceable motherboard for system upgrades or repairs
Specifically for use with GEMC-128 control panels

SLC-3LSFL-SLC3LS

Fire-Lite SLC-3LS 318-Point Addressable SLC Signaling Line Circuit Expander Card for ES-1000X

SLC-3LS|FL-SLC3LS

Key Features

Optional card that provides the ES-1000X Series Fire Alarm Control Panels with additional SLC communication loops
A maximum of two SLC3-LS cards may be installed on the Fire Alarm Control Panel
Offering a total of 3 SLC loops and 954 points in the system

49840600H49840600

Honeywell 49840600 Special Video XO USB IFace IO MIO+EIO

49840600|H49840600

ANU-48LE-ANU48

Honeywell ANU-48 LED Driver Module, 24V DC

ANU-48|LE-ANU48

Key Features

Includes input for eight software programmable switches, maintained on momentary contact
Provides output for up to 48 remote LEDs or driver circuits
Installed up to 3,000'(914.4 m) from the control panel, and up to 15 additional annunciators can be connected

DS7457IFDS-DS7457IF

Bosch

Bosch DS7457IF Input Module for Fire, Single-Zone

DS7457IF|DS-DS7457IF

Key Features

Address settings through DIP switches
Compact enough to fit within most back boxes and enclosures
Power-limited and supervised input zones

FSUIMED-FSUIM

Kidde FSUIM Universal Interface Module

FSUIM|ED-FSUIM

LDM-32LE-LDM32

Light Engineered

Light Engineered LDM-32 PREMOUNT and WIRE LED DRIVER MOD

LDM-32|LE-LDM32

Key Features

ALARM/CIRCUIT ON and TROUBLE lA/LED per-point option, or more dense alarm-only option (field selectable).
Control switch option for remote control per point
LAs/LEDs may be programmed to display status of indicating circuits or control relays as well as system status conditions.

SIGA-CC1ED-SIGACC1